Happy World Card Making Day

A week late ;)

I meant to post this last weekend and didn't get a chance. I shared the directions for this card for CompuPro and wanted to share them here as well.

Supplies:



Cardstock- Chocolate Chip (10 x 5)
- Baja Breeze (4 ¾ x 4 ¾)
- White (scrap)
Pattern Paper
Chipboard
Ribbon
Ink (pink for bird and brown for sponging)
Nestabilities (scallop square and plain square)
Stamp
Stickles
Brads
Paper piercer

Step 1: Make the frame using Nestabilities. Place the A plate on the bottom of your “sandwich” then the B plate. Put chipboard piece on B plate and then create the frame as shown. Make sure the dies don’t touch as they could crack. If you need to you can use a very small piece of tape to hold them in place but if you use too much it may be too thick to go through. Place C plate on top and put through Cuttlebug.



Step 2: Cut pattern paper using same scallop square.



Step 3: Adhere patterned piece to frame, turn over and use craft knife to cut inside of frame.



Step 4: Stamp bird image and cut excess off that will show behind the frame. Adhere to back of frame and add brads.



Step 5: Sponge edges of patterned paper and baja breeze cardstock and stamp sentiment on bottom.



Step 6: Add ribbon. This is a little tip on how I add my ribbon with a few extra pictures to show what I am talking about as I don’t think I can explain it very well. LOL!

a. To measure my ribbon I go by the length of my card/LO and add a couple of inches for the knot.

b. Tie ribbon as if you were tying it around something.



c. If you want the bow on the side, cut the ribbon about 1/3 of the way around the loop from the knot. If you want it in the middle cut it in half.



d. Tape ribbon on back.



Step 7: Add stickles.



Finished card:



Finished card size is 5 x 5.